Refrigerator Capacitor Snap in Aluminum Electrolytic Capacitor for Refrigerators

                 Item

                                                            Features

        Temperature 

                 (16V ~ 100V)  -40°C ~ +105°C   (160 ~ 450V)  -25°C ~ +105°C

       Voltage Range

                                                          16V ~ 500V

    Capacitance Range

                                         68uF ~ 47,000uF         20°C,120Hz

 Capacitance Tolerance

                                                                 ±20%

     Leakage Current

≤0.01CV (C: Rated capacitance; V: Rated voltage) or 1.5mA, which ever is the smaller,  5 minutes test at 20°C.

        Maxinmun DF

                                                     0.15    at 20°C, 120Hz 

 Temperature Features

                                                   C (-25°C )/C(+20°C )≥0.6

  Insulating Resistance

The value measured by applying DC 500V insulation resistance tester between all terminals and snap ring withinsulating sleeve ≥100MΩ

    Insulating Voltage

Apply AC 2,000V between all terminals and snap ring with insulating sleeve for 1 minute and no abnormality appears.

          Durability

Apply rated ripple current on capacitor with voltage not more than rated voltage under 105°C environment and apply rated voltage for 3,000 hours, then recover to 20°C environment and the test results should satisfy the requirements as below
Capacitance change rate (C)≤initial value±15%
DF(tgδ)≤200% of inital specifications value
Leakage current ≤inital specifications value

High-temperature Zero Load Feature

capacitor is kept in 105°C environment for 1,000 hours, then test in 20°C environment and the test results should satisfy the requirements as below
Capacitance change rate (C)≤initial value±15%
DF(tgδ)≤150% of inital specifications value
Leakage current ≤inital specifications value
(Voltage pretreatment should be done before test: apply rated voltage on both ends of capacitor through a resistor about 1,000Ω for 1 Hrs, then discharge electricity through 1Ω/V resistor after pretreatment. Place capacitor under normal temperature for 24 Hrs after total discharging, then starts test.